Car Tinting Film - 75x300cm, Car Glass, BLACK 5% VLT [BLACK]

BLACK BLACK 5% VLT [BLACK]

Characteristics:

• Black colour;
• 5% VLT, Transmitted Light;
• Dimension: 75cm x 300cm.

For correct application:

1. Cut the necessary part from the roll to size.
2. The protective film is located on the inside of the roll.
3. To remove the protective film, use some paper tape, a small piece to glue in a corner to be able to raise one edge (the transparent protective film).
4. If the climate is particularly dry, electrostatics will make the job difficult.
5. To overcome the problem, always use paper tape to keep the film stretched out on a surface (table). When removing the protective film, pay close attention to ensure that the part to be applied to the glass does not crumple on itself. To eliminate electrostatic charges, wet with soapy water (dish detergent is excellent) as soon as possible (the ideal is to use an empty container with a spray jet).
6. Wet the glass with the same water. It is better to use a large quantity of water.
7. At this point, take the sheet carefully and place it on the glass. It will stick on its own.
8. Move it into place and use the spatula to push out the water and eliminate any remaining bubbles.

By following the instructions you should have no problems with the application.